Vxl-instruments Itona D Series Thin Client - Service Manual Manual de usuario

Itona D Series Service Manual

Replacing Flash 6 4 Replacing Flash To replace Flash: 1. Remove the power adapter, pedestal and side cover. For more information see, section ‘E

7 Replacing COM3 Port 5 Replacing COM3 Port To replace the COM3 port: 1. Remove the power adapter, pedestal and side cover. For more information s

Replacing COM3 Port 8 4. Unplug the COM3 port cable from the motherboard. 5. Replace this COM3 port with a new one.

9 Replacing Audio Board 6 Replacing Audio Board To replace the COM3 port: 1. Remove the power adapter, pedestal and side cover. For more informati

Replacing Motherboard 10 7 Replacing Motherboard To replace the motherboard: 1. Remove the power adapter, pedestal and side cover. For more inform

11 Replacing Motherboard Figure 13: Remove Motherboard Screws 5. Remove the motherboard as shown in the following figure. Figure 14: Motherboard

Copyright © 2004-2013 VXL Instruments Limited. All Rights Reserved Information in this document is subject to change without notice and does not rep

Table of Contents 1 Tools Required 1 2 Pedestal and Side Cover 3 Removing Pedestal and Side Cover 3 Fixing the Pedestal and Side Cover 4 3 Re

Warning and Caution Statements Warning: It is best to wear an electrostatic discharge (ESD) cuff when handling electronic components (Motherboard

1 Tools Required 1 Tools Required The tools required for servicing the Itona C Series Thin Client are shown in Figure 1. Figure 1: Tools Required

Tools Required 2 B. Phillips screw driver C. Hex Nut driver 5.0 mm D. Nose pliers with spring

3 Pedestal and Side Cover 2 Pedestal and Side Cover Removing Pedestal and Side Cover The procedure to remove the power adapter, pedestal and top cov

Pedestal and Side Cover 4 Note: Retain the screws for future use. 5. Slide the side cover and remove it as shown in Figure 4. Figure 4: Removing

5 Replacing RAM 3 Replacing RAM To replace RAM: 1. Remove the power adapter, pedestal and side cover. For more information see, section ‘Error! Re